I like snakes. More accurately, I like harmless snakes in nature where they belong. It's always a thrill to see a garter snake or a gopher snake in the backyard, where I know they are helping to keep the rodent population down. While technically it is a thrill to see a rattlesnake, I can live without ever having that thrill again. Fortunately, it is easy to tell the difference between dangerous and harmless snakes here in Northern California. As long as it doesn't have a triangular head and a rattle on its tail, it's welcome to visit my backyard.
Today's project is a moveable garter snake, made from a paper plate. Both Massachusetts and Virginia have named the garter snake as their state reptile. Give this easy project a try! Affiliate links below.
Paper Plate Garter Snake
Materials:
Steps:
Cut the rim of the paper plate away from the center. Use the center to cut the snake's head. Cut the rim into four sections that are approximately the same size.
Paint the head and each of the sections brown. When the paint is dry, add a Camel stripe down the center of each body section and along the edges.
Line up two body parts so that they overlap slightly, use the craft pick to poke a hole, and connect the two pieces with a brad. Continue until all four body pieces are connected. Then connect the head to one end of the body.
Use the scissors to round off the tail end of the snake.
Draw a pupil on the enamel dots, then stick the dots to the snake's face. (I drew them vertical, but it appears they should be round. There is a lot of conflicting information about snake pupils.) Draw on two nostrils.
I positioned my snake in the dirt to take photos. For a paper plate, I think it looks pretty convincing!
Great use of the paper plates to make the snake!
ReplyDelete